Xerox WORKCENTRE C2424, Service Manual

Page: 255 / 432

Image-Quality Troubleshooting 5-15
The Printed Image Is Too Light or Too Dark
No Image is Being Printed
The system processes a sheet of paper, but no image is printed on it.
Note
Blank sheets accompanying multi-picks or chase pages following a jam are a part
of normal operation.
Step Questions and Actions Yes No
1 1.
Verify the paper type at the control panel
matches the paper type in the driver and in
the software application being used,
especially if printing on transparency.
2.
Verify the paper type is a supported media
type for this system.
3.
Did this correct the problem?
Complete. Go to Step 2.
2 1.
Change/adjust the print mode settings.
2.
Did this correct the problem?
Complete. Go to Step 3.
3 1.
The ink may be discolored due to age or lack
of use over an extended period of time.
2.
Insert new ink and print a solid fill test print.
Run the test print until the affected color
returns to normal.
3.
Did this correct the problem?
Complete. Go to Step 4.
4 1.
If the problem is occuring for only one color,
purge the ink up to 10 times to clear the ink
or until discoloration is cleared.
2.
Did this correct the problem?
Complete. Replace the
printhead.
Step Questions and Actions Yes No
1 1.
Inspect the area around the printhead and
drum and remove any media or bits of paper
jammed between the printhead and drum.
2.
Did this correct the problem?
Complete. Go to Step 2
2 1.
Follow the instructions on the “Printhead
Troubleshooting Checklist”.
2.
Did this correct the problem?
Complete. Go to Step 3.
3 1.
Inspect and reseat the wave amp and data
cables connecting to the printhead.
2.
Replace or repair any defective cables.
3.
Did this correct the problem?
Complete. Replace in the
following order:
■
electronics
module
■
printhead