Safety
10
Phaser 7100 Color Printer
User Guide
Electrical Safety
General Guidelines
WARNINGS:
•
Do not push objects into slots or openings on the printer. Touching a voltage point or
shorting out a part could result in fire or electrical shock.
•
Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are instructed to do so. Turn off the printer when
performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are
no parts that you can maintain or service behind these covers.
The following are hazards to your safety:
•
The power cord is damaged or frayed.
•
Liquid is spilled into the printer.
•
The printer is exposed to water.
•
The printer emits smoke, or the surface is unusually hot.
•
The printer emits unusual noise or odors.
•
The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1.
Turn off the printer immediately.
2.
Disconnect the power cord from the electrical outlet.
3.
Call an authorized service representative.
Laser Safety
This printer complies with laser product performance standards set by governmental, national, and
international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous
light because the beam is totally enclosed during all modes of customer operation and maintenance.
WARNING:
Use of controls, adjustments, or performance of procedures other than those specified in
this manual can result in hazardous radiation exposure.
