Xerox Phaser 6180MFP, Service Manual

Page: 494 / 884

4-82 Phaser 6180MFP Multifunction Printer Service Manual
General Troubleshooting
7 Check the Toner Sensor Harness for
continuity.
1. Disconnect the wiring harnesses from the
MCU Board and the Print Cartridge
Sensor.
■
Yellow: P/J19 and P/J191
■
Magenta: P/J19 and P/J192
■
Black: P/J19 and P/J193
■
Cyan: P/J19 and P/J194
2. Check continuity between P/J
connectors:
■
Yellow: P/J19 <=> P/J191
■
Magenta: P/J19 <=> P/J192
■
Black: P/J19 <=> P/J193
■
Cyan: P/J19 <=> P/J194
Go to step 8. Replace the
Toner Sensor
Harness.
8 Check the Print Cartridge Sensor signal.
1. Disconnect the wiring harness connector
P/J19 from the MCU Board.
2. Is there +3.3 V across the Toner Sensor
Harness?
■
Yellow: J19-1 <=> J19-2
■
Magenta: J19-4 <=> J19-5
■
Black: J19-7 <=> J19-8
■
Cyan: J19-10 <=> J19-11
Go to step 9.
■
Replace the
MCU Board
(page 8-88).
9 Check the Print Cartridge Sensor for
operation.
1. Measure the voltage across:
■
Ground <=> P/J19-3 (Yellow)
■
Ground <=> P/J19-6 (Magenta)
■
Ground <=> P/J19-9 (Black)
■
Ground <=> P/J19-12 (Cyan)
2. Does the voltage change when the paper
is inserted into the sensor detecting
point?
Replace the
MCU Board
(page 8-88). Replace the
Print
Cartridge
Sensor.
■
Black
(page 8-57)
■
Yellow/
Magenta/
Cyan
(page 8-58)
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No