Xerox Phaser 6180MFP, Service Manual

Page: 361 / 884

Phaser 6180MFP Multifunction Printer Service Manual 3-173
Error Messages and Codes
File Size Limit
File size error is over the maximum file size in file conversion. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
■
Chain Link 016-986 : File Size Limit (File Size Error)
Initial Actions
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
1. Turn the printer power Off and back
On.
2. Does the error still occur?
Go to step 2. Complete.
2
1. Check the Country setting
information on the Control Panel:
System > Admin Menu > Fax
Settings > Country .
2. Is the Country setting correct?
Go to step 3. Change the
Country Setting
to the correct
country.
3
1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when the
printer is turned On?
Replace the
Scanner
Controller Board
(page 8-99). Complete.