Xerox Phaser 3330, Service Manual

Page: 127 / 434

Troubleshooting
Phaser 3330 and WorkCentre 3335/3345 Xerox Internal Use Only
Service Manual
2-68
Over Heat Error
The Fuser exceeded the temperature set point.
Applicable Error
• 10-300: Over Heat error
Initial Actions
• Check the Fuser and Fan vents for debris.
• Turn the Machine off and then on again.
• If the problem persists continue troubleshooting.
Troubleshooting Reference Table
WARNING: Do not touch the fuser while it is hot.
Troubleshooting Procedure Table
Applicable Parts Wiring and Plug/Jack Map Reference
• Thermistor, (PL 3.3.2, Parts List 3.3 Fuser )
• Fuser, (PL 3.3.36, Parts List 3.3 Fuser )
• Phaser 3330 Main PWB Connector Designators
• Phaser 3330 Control Panel PWB
• Wiring Diagrams for P3330/WC3335/WC3345
• WorkCentre 3335/3345 Main PWB Connector Designators
• DADF PWB
• SMPS PWB
Step Actions and Questions Yes No
1. Remove then reinstall Fuser.
Does the error persist? Go to step 2. Complete.
2. • If the problem persists, turn the machine
off and remove the Fuser (PL 3.3.36,
Parts List 3.3 Fuser ).
• Check if the Fuser connector is
connected properly (CN 3).
• Check if the input voltage is normal.
• Check if the Thermistor is twisted or
contaminated. Clean or replace the
Thermistor (PL 3.3.2,
Parts List 3.3 Fuser ).
Does the error persist?
Install a new Fuser (PL
3.3.36,
Parts List 3.3
Fuser ).
If the problem persists
Install a new Main PWB:
• Phaser 3330 (PL
1.0.7, Parts List 1.0
Phaser 3330 Main )
• WorkCentre 3335 and
3345 (PL 6.1.7, Parts
List 6.1 WorkCentre
3335/3345 Main
).
Complete.