Xerox Document Centre ColorSeries 50, User Manual

Page: 54 / 261

DOCUMENT CENTRE CS 50 USER GUIDE 2–21 GETTING TO KNOW YOUR COPIER / PRINTER
1
2
3
4
5
6
7
Ground fault protection
The Document Centre ColorSeries 50 copier/
printer is equipped with a safety feature called a
Ground Fault Protector, Figure 18. This device
removes all electrical power to the copier/printer if
a fault is detected in the power supply to the
copier/printer.
If power is interrupted to the copier/printer,
perform the following:
1
Locate the Ground Fault Protector on the back of
the copier/printer in the lower left corner.
2
Flip the switch up if the device has been tripped
and the switch is in the Off (down) position.
If the device interrupts power to the copier/printer
again, or if power has not been restored by the
above procedure, call your Xerox service
representative.
CAUTION: The Fuser Roll remains in a cammed-
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
powered on and a copy/print made as soon as the
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
Figure 18: Ground Fault Protector