Xerox Document Centre ColorSeries 50, User Manual

Page: 124 / 261

DOCUMENT CENTRE CS 50 USER GUIDE 2–27 ADDED FEATURES
1
2
3
4
5
6
7
Variable Erase for edges
The Variable Erase option, illustrated in Figure 29,
enables the copier/printer to vary the amount of
erasure from 0 to 50 mm in 1 mm increments. The
same amount of erasure is applied to both top and
bottom edges or right and left edges of the
document.
The Centre Area Erase option allows you to
remove the shadow caused by the centre binding
of bound documents when they are copied. The
factory default setting for Centre Erase is 0 (zero).
Select the up arrow to increase the amount of
erasure or the down arrow to decrease the
amount of erasure.
KEY POINT: If your document contains an image
area that extends to the edges of the document,
and you do not want any of it to be deleted, use
the Variable Erase arrow buttons to set the erase
value to zero. Select the Margin Shift feature, Auto
Shift option, from the Added Features tab. Ensure
that 100% is selected for Reduce/Enlarge feature
on the Basic Copying tab.
NOTE: Keep the following notes in mind when
using Centre Area Erase:
•
Do not use Centre Area Erase with the
following features:
– Multiple-Up
– Repeat Image
•
The Centre Area Erase setting in the Variable
Erase feature is the same as the centre erase
setting of Bound Originals.
•
For some original image sizes, Centre Area
Erase does not occur exactly in the centre of
the output image.
Figure 29: Variable Erase screen