Page 2
Port 9100 TCP/IP Printing Quick Install Card
Xerox Document Centre 460/470 ST
Go to a workstation and...
1.
Create a test job and send it to the printer
with a workstation utility or through a
queue on your operating system that sup-
ports Port 9100 printing.
2.
Check your test job for quality and use the
problem solving section of the
Document
Centre 460/470 Reference Guide
for
resolving print defects.
3.
If your print job does not print, refer to the
troubleshooting section in the document
entitled
Network Installation and
Troubleshooting Guide
to correct the
problem.
4.
Repeat this
Go to a workstation and...
procedure at each workstation that will
print to this printer or at other servers
where a queue has been created.
6.
Set the Subnet Mask and Gateway.
a)
Press the
Subnet and Gateway
button.
b)
Press the soft buttons on the Touch
Screen one at a time for each octet of
the Subnet Mask and enter the
numbers using the keypad. Repeat
this process for the IP Gateway
address. When finished press
Save
to
record the changes and exit to the
TCP/IP Settings
screen.
NOTE: The Broadcast Address will be calcu-
lated automatically.
7.
Enable
Port 9100
printing .
a)
Press the
Port 9100 printing
button.
b)
At the next screen press
Enable
then
press
Save
.
8.
Exit the Tools Menu
a)
Press the
Exit Tools
button.
