Page 1
DHCP / BOOTP Dynamic IP Address Assignment Quick Install Card
Xerox Document Centre 460/470 ST
Go to the printer and...
2.
Connect your Document Centre to the
network with the appropriate cabling.
3.
Enter the
Tools
pathway
a)
Press the
Access
( )
button.
b)
On the keypad enter
1111
or the
current password. Press the
Enter
button when finished. Press the
Go to
Tools
button.
c)
The Touch Screen will be used for the
remainder of the data entry.
4.
Enter the Network Setup menus.
a)
Wait for the screen to refresh and
press the
Connectivity and Network
Setup
button.
b)
Wait for the screen to refresh and
press the
Network Setup
button.
c)
Press the
TCP/IP Options
button.
5.
Enable TCP/IP printing.
a)
Press the
TCP/IP Settings
button.
b)
Press the
Protocol and Media
button.
c)
Press the
Enable
button. If Physical
Media buttons appear, select either
Ethernet
or
Token Ring
. Press
Save
.
6.
Set the Host Name (skip steps 6a-6c if
your DHCP server supplies this
information).
a)
Press the
Name/Address
button.
b)
Press the
Host Name
button.
c)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the
Save
button to
record the changes and exit to the
TCP/IP Settings
Screen.
7.
Set the Subnet Mask and Gateway (skip
steps 7a-7b if your DHCP server supplies
this information). The Document Centre
will only accept one Gateway address
from the DHCP server.
a)
Press the
Subnet and Gateway
button.
b)
Press the soft buttons on the Touch
Screen one at a time for each octet of
the Subnet Mask and enter the
numbers using the keypad. Repeat
this process for the IP Gateway
address. When finished press
Save
to
record the changes and exit to the
TCP/IP Settings
Screen.
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the
100BaseT Ethernet and Token
Ring Interface Quick Install Card
to configure
the Speed and Source Routing settings for your
environment. Then return to this card and follow
the instructions.
NOTE: By default, DHCP is enabled on the
Document Centre. This card will show you
how to disable DHCP (or enable it if it was
disabled) and set your TCP/IP information
using BOOTP.
DHCP servers vary in the information that they
return to the host computer requesting service.
Your Document Centre can retrieve the following
values from a DHCP server:
TCP/IP Address
Host Name
Subnet Mask
Gateway TCP/IP Address
Broadcast Address
Consult the documentation supplied with your
DHCP server software to verify what TCP/IP
information it is capable of supplying.
Go to the DHCP server and...
1.
Configure the DHCP server with the TCP/
IP information you want assigned to your
printer. Use the documentation supplied
with your server software for this task.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
