Page 1
WINS (Windows Internet Name Service) Quick Install Card
Xerox Document Centre 460/470 ST
Go to the printer and...
1.
Connect your Document Centre to the
network with the appropriate cabling
2.
Enter the Tools pathway
a)
Press the
Access
( )
button.
b)
On the keypad enter
1111
or the
current password. Press the
Enter
button when finished. Press the
Go to
Tools
button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the
Connectivity and Network
Setup
button.
b)
Wait for the screen to refresh and
press the
Network Setup
button.
c)
Press the
Microsoft Networks
button.
4.
Enable the Transport and Media
a)
Press the
Transport and Media
button.
b)
Press the
Enable
button. If Physical
Media buttons appear, select either
Ethernet
or
Token Ring
. Press
Save
.
5.
Set the NetBIOS Host Name
a)
Press the
Workgroup and Host
button.
b)
Press the
SMB Host Name
button.
c)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the
Save
button to
record the changes.
d)
Press the
Exit Tools
button.
e)
The Document Centre will reconfigure
itself with the new settings and
automatically register its TCP/IP
address and NetBIOS host name with
your WINS server.
Go to the workstation and...
1.
Create a new lpr printer on the NT
workstation
a)
With an LPR port as the desired
destination, enter the Microsoft
Networking host name.
b)
Enter a queue name to identify the
printer.
c)
When prompted, select the desired
PostSricpt or PCL driver from the
CentreWare Network Services CD
or
a directory where drivers are stored.
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the
100BaseT Ethernet and Token
Ring Interface Quick Install Card
to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
Your Document Centre now has DHCP, LPR,
and NetBIOS over the IP protocol enabled by
default. If your DHCP server will provide host
name, IP address, Gateway address, and Sub-
net Mask, the Document Centre TCP/IP infor-
mation will be configured on initial boot.
This means that if you have configured your
DHCP server with the desired information, you
may connect your Document Centre to your net-
work and it will boot and register with the WINS
server automatically.
In this mode the default host name for the device
will be the letters
XRX
followed by the MAC
address of the network interface. Example:
XRX08003E313E0A
If this host name is acceptable you can go right
to the section on this card entitled
Go to the
Workstation and....
and complete those steps.
To change the
host name
for your printer follow
Steps 1,2, and 3 then skip to Step 5 and finish
the Go to the Printer... portion. When you finish
that section, go to the section on this card
entitled
Go to the Workstation and....
and
complete those steps.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
