XENO XDR5K4, Setup And User'S Manual

Page: 132 / 187

132
Figure 10.8 NTP Settings Interface
3. Check the Enable NTP checkbox to enable this feature.
4. Configure the following NTP settings:
•
Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server: IP address of NTP server.
•
NTP Port: Port of NTP server.
5. Click the Apply button to save and exit the interface.
Note: The time synchronization interval can be set from 1 to 10080min, and the default value is 60min. If the DVR is
connected to a public network, you should use a NTP server that has a time synchronization function, such as the
server at the National Time Center (IP Address: 210.72.145.44). If the DVR is setup in a customized network, NTP
software can be used to establish a NTP server used for time synchronization.
10.2.3 Configuring Email
Purpose:
The system can be configured to send an Email notification to all designated users if a motion event is detected, etc.
Before configuring the Email settings, the DVR must be connected to a local area network (LAN) that maintains an
SMTP mail server. The network must also be connected to either an intranet or the Internet depending on the location
of the e-mail accounts to which you want to send notification.
Steps:
1. Enter the Network Settings interface.
Menu > Network > Network Settings
2. Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the Network Settings
menu.