XENO XDR5K4, Setup And User'S Manual

Page: 163 / 187

163
Figure 11.21 Copy Settings to Other Camera(s)
6. Select the camera (s) to be configured with the same quota settings. You can also click the checkbox of All to
select all cameras.
7. Click the OK button to finish the Copy settings and back to the Storage Mode interface.
8.
Click the Apply button to apply the settings.
Note: If the quota capacity is set to 0 , then all cameras will use the total capacity of HDD for recording.
11.2.5 Checking HDD Status
Purpose:
You may check the status of the installed HDDs on DVR so as to take immediate check and maintenance in case of
HDD failure.
Checking HDD Status in HDD Information Interface
Steps:
1. Enter the HDD Information interface.
Menu > System > Disk > Advanced
2. Check the status of each HDD which is displayed on the list, as shown in Figure 11.22.