XENO XDR5K4, Setup And User'S Manual

Page: 59 / 187

59
•
Frame Rate: Set the frame rate of recording.
•
Max. Bitrate Mode: Set the mode to General or Customize (32-3072Kbps).
•
Max Bitrate (kbps): Select or customize the maximum bit rate for recording.
4) Configure the pre-record, post-record time, expired time, redundant record (this option is only
available when the HDD mode is Group ) and whether you want to record audio.
•
Pre-record: The time you set to record before the scheduled time or event. For example, when an alarm
triggered the recording at 10:00, if you set the pre-record time as 5 seconds, the camera records it at
9:59:55.
•
Post-record: The time you set to record after the event or the scheduled time. For example, when an
alarm triggered the recording ends at 11:00, if you set the post-record time as 5 seconds, it records till
11:00:05.
•
Expired Time (day): The expired time is the longest time for a record file to be kept in the HDD, if the
deadline is reached, the file will be deleted. You can set the expired time to 0, and then the file will not be
deleted. The actual keeping time for the file should be determined by the capacity of the HDD.
•
Redundant Record: Enabling redundant record means you save the record files in the redundant HDD.
See Chapter 6.5 Configuring Redundant Record .
Note: The Redundant Record option is only available when the HDD mode is Group. The redundant
record is to decide whether you want the camera to save the record files in the redundant HDD. You must
configure the redundant HDD in HDD settings. For detailed information, see
Chapter 11.2.3 Managing
HDD Group .
•
Record Audio: Check the checkbox to record the sound, or uncheck to record the image without sound.
•
Enable 960Mode: Enable the high-speed download mode. You can also uncheck the checkbox to
disable it.
5) You can copy the settings to other channels by clicking Copy , if the setting can also be used for other
channels.
Figure 6.4 Copy Camera Settings
6) Click Apply to save the settings.
Note: You can click the Restore button to restore the current main stream settings to the default parameters.
3. Set encoding parameters for sub-stream
1) Click the Substream tab to enter the Substream settings interface.