Xantrex Trace SW4024, Installation Manual

Page: 26 / 56

2.0 INSTALLATION
20
© 2002 Xantrex Technology Inc.
P/N 975-0041-01-02 Rev A 03/02
Wiring (continued)
Communications Cable
Figure 2-6
GTI Communications Cable Location
1. Remove the access panel on the bottom of the inverter.
2. Clip the cable binding and gently remove the loose end of the
communications cable from inside of the inverter. It will be located directly
behind the AC Terminal Block. This cable extends approximately 2.5 feet
out of the inverter.
3. Connect the loose end of the communications cable to the communications
cable port on the GTI circuit board.
See Figure 2-7 for the location of the communications port inside the
GTI.
Communications
Cable
Remove this
screw to remove
the access panel.
Remove this screw
to remove the
access panel.
Cable binding