Installation
975-0126-01-01
15
Installation Tools and Materials
Tools
You will need the following tools to install the RS2000 and the battery
temperature sensor.
❐
Wire stripper
❐
Crimping tools for fastening lugs and terminals on DC cables
❐
Phillips screwdriver: #2
❐
Slot screwdriver (¼" wide blade max.)
❐
Needle-nose pliers
❐
Wrench for DC terminals: 9/16"
Materials
You will need the following materials to complete your installation:
❐
Strain-relief clamp (s) for AC cables
❐
DC battery cables
❐
Terminals and/or crimp connectors for DC cables
❐
AC and DC disconnect switches and over-current protective devices and
connectors as required
❐
Copper wire for DC grounding: No. 8 AWG
❐
Cables for AC output and input wiring
❐
Six ¼"–20 1.25" length steel screws or bolts to mount the RS2000
For a list of tools and materials required to install the network, refer to the
Xanbus
System Installation Guide,
which is available for download at
www.xantrex.com
.
Summary of Contents for RS2000
