Installation
28
975-0126-01-01
DC Grounding
The Chassis Ground point on the inverter/charger is used to connect the chassis of
the inverter/charger to your system’s DC grounding point, as required by
regulations for some installations. Use copper wire that is either bare or provided
with green insulation.
The grounding guideline given below assumes you are using the code-compliant
DC supply cable and fuse sizes indicated in this Installation Guide. If you are
using different sizes, refer to the applicable code for DC grounding detail.
To connect the chassis ground:
1. Using the appropriate screwdriver, loosen the screw on the chassis ground
point shown in Figure 9.
2. Connect a No. 8
AWG copper cable between the chassis ground point and the
DC grounding point for your system.
In an RV or vehicle installation, this will usually be the vehicle chassis or a
dedicated chassis ground bus.
3. Tighten the screw to a torque of 1.0–1.25 ft-lbs (1.47–1.7 Nm).
Figure 9
Completed DC Wiring and DC Grounding
!
chassis ground
point
Summary of Contents for RS2000
