IEC-2001
10/100/1000 Industrial Media Converter, SC MM 550M, -40 to 75C
Quick Installation Guide
v1.00
‐
1209
IEC-2001 Page
1
Overview
LevelOne IEC-2001 is an industrial Gigabit Ethernet media converter
with a rugged aluminium case which providing superb heat
dissipation. This converter is designed to be mounted on an
industrial standard DIN-rail, plus the clearly visible status LEDs
provide simple monitoring of port link activity. It also features Link
Fault Pass Through in order to alert remote location when link
status changes
Fault Detection
Relay contact sends alert signal when the power failed or a port link
disconnected, therefore the system operator can respond quickly.
This relay contact can be easily configured with a simple DIP switch
High Reliability
All components are built to withstand harsh environment
applications without compromise where humidity, temperature
variation and even shock vibration are concerns, including Electric
& Utility, Critical Infrastructure, Transportation and Surveillance
Security. This device operates under -40 to 75 Celsius (-40 to 167
Fahrenheit) temperature.
Safety
Complies with NEMA (National Manufacturers Association) TS1 &
TS2 Environmental certified for the Traffic Control Equipment that
withstand extreme temperatures, operating voltage and humidity
fluctuation, vibration and shock commonly experienced in severe
outdoor environments.
IEC-2001 Page
2
Features
Complies with NEMA TS1 & TS2 Environmental requirements for
Traffic control equipment
Complies with IEC61000-6-2 EMC Generic standard immunity for
Industrial environment
Supports 1000SX Multimode SC fibre up to 550 meters
DIP switch configuration for "Link-Fault-Pass-Through," link
down alarm, speed, duplex mode
1000Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX
Full wire-speed forwarding rate
Alarms for power and port link failure by relay output
-40°C to 75°C (-40°F to 167°F) operating temperature range
IP30 aluminium case
Supports DIN-rail mounting installation
Package Contents
IEC-2001
Quick Installation Guide
IEC-2001 Page
3
LED Status
LED
Status
Description
PW 1,2,3
Steady Power
On
Off Power
Off
FAULT
Steady
Redundant Power or Ports are failed
Off
Redundant Power or Ports are normal
LNK/ACT
Steady
Network connection is established
Flashing
Transmitting or Receiving data
Off
No connection occurred
FDX/COL
Steady Full
duplex
mode
Flashing Collision
occurred
Off Half
duplex
mode
1000
Steady
Connection at 1000Mbps speed
Off No
connection
100
Steady
Connection at 100Mbps speed
Off
Connection at 10Mbps speed
LFPT
Steady LFPT
is
enabled
Off
LFPT is disabled
LFPT
: Link Forward Pass Through
