WTC MedWeld 3005, Operator'S Manual

Page: 53 / 206

9^cdQ\\Y^WdXU=UTGU\T# %
=UTGU\T# %?`UbQd_bµc7eYTUD)## " "!#
= #" "%1`bY\" "
>?D5*
If the computer interface pod is faulted (the Red LED is ON), power the
interface pod switch OFF, then ON, to clear the fault.
4. Select YES to go on-line. Note the ONLINE status at the
bottom of the main screen.
1RGH&RPPLVVLRQLQJ³5RERW
Follow these steps:
1. Under UTILITIES , select NODE COMMISSIONING .
2. Select
MINI WHO
to confirm the node addresses. (They will
likely be zero for the DeviceNet card. The computer interface
is 62.)
1^5hQ]`\U*
In this example, MINI WHO found node addresses 00 and 62.
Configure the DeviceNet Card as NODE 30 with the following
procedure. This is used in any control from single- through six-
pack:
1. Close MINI WHO .
2. Change the current node address to the value found using
MINI WHO
.
3. Change the new node address to NODE 30 and a 500 kB/sec.
data rate. Do it in two steps, as follows:
Node 62 @ 125 kB Select GO ON LINE then YES, GO ON LINE
Node 62 @ 500 kB Select GO ON LINE then YES, GO ON LINE
Node 62 @ 250 kB Select GO ON LINE then YES, GO ON LINE
WTC NODE ADDRESSING METHOD ROBOT [5 byte transfer]
NODE 03 Used as the Master to control (REV 02.04 & UP)
a WTC Weld Control
NODE 30 In a WTC Weld Control, for (REV 02.04 & UP)
SCR1 through SCR3