WTC MedWeld 3005, Operator'S Manual

Page: 151 / 206

CdU``Ub4QdQ
=UTGU\T# %?`UbQd_bµc7eYTUD)## " ''
= #" "%1`bY\" "
END OF STEPPER :
This parameter sets the maximum weld count for a SureWeld
stepper. When the stepper has completed the number of
welds specified by the parameter, the control generates an
END OF STEPPER fault. This fault is reset by the STEPPER
RESET input.
ALERT POINT%I: (99%)
This parameter defines the point where the SCR alerts you
when the stepper is approaching maximum heat, if the SCR
firing mode is AVC.
ALERT POINT (CURRENT): (99999)
This parameter defines the point where the SCR alerts you
when the stepper is approaching the maximum current
(while the SCR firing mode is ACC).
>?D5*
When the control detects that the heat (or secondary current) has reached
the alert point programmed, it generates the STEPPER
APPROACHING MAX. condition.
STEPPER APPROACHING MAX.: (99999)
When the weld count reaches this limit, the MedWeld 3005
generates the STEPPER APPROACHING MAX. condition, to
indicate that the electrodes require maintenance.
'LVSOD\DWWKH
'(36
When selecting the SureWeld stepper status display from the
DEP-100S, use this display to check the status of the SureWeld
steppers:
@?G5B?>3?==?>
CEB5CD5@@5BCD1DEC*=Qh!3i4b_`
2__cd* D_dQ\GU\Tc-
ED- 4D- >_5h`- 5h`-
Cd`b !_^bUcUdgSe
6!6"6#6$