WTC MedWeld 3005, Operator'S Manual

Page: 200 / 206

dnet_map Welder Outputs—Node 30
Host Input Image Table (Node 30)
Bit
Global SCR#1 SCR#2 SCR#3 SCR#4 SCR#5 SCR#6
Byte 0
a
a. This byte is used to identify the application information that is to be sent by the scanner while operating in Slave mode. Bits #0-2 are used to identify
the provider of the information. The following are currently defined providers and their ID numbers:
WTCID = 1 binary = (001)
ABBID = 2 binary = (010)
Bits #3-5 are used to identify the amount of information to be transferred. The size will be the amount of information to be transferred. The size will
also indicate the amount of output bytes that contain actual data. (The input size will always equal the output size.) Bit #7 is currently a spare and
should be filled with a 0.
Byte 1
b
b. For a definition of the signals in bytes 1-7, refer to “I/O Definitions” on page 3-5.
Byte 2
b
Byte 3
b
Byte 4
b
Byte 5
b
Byte 6
b
Byte 7
b
00 ID BIT #0 CONTACTOR IS
OPEN I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE
01 ID BIT #1 STEPPER
APPROACHING
LAST STEP WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS
02 ID BIT #2 END OF STEPPER/
END OF CAP LIFE NO FAULT NO FAULT NO FAULT NO FAULT NO FAULT NO FAULT
03 SIZE BIT #0 SPARE ALERT ALERT ALERT ALERT ALERT ALERT
04 SIZE BIT #1 SCR #1 TIP DRESS
REQUEST END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE
05 SIZE BIT #2 SCR #2 TIP DRESS
REQUEST STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET
06 SIZE BIT #3
MACHINE INPUT #1
c WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE
07 SPARE
MACHINE INPUT #2
c READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD