WTC MedWeld 3005, Operator'S Manual

Page: 202 / 206

dnet_map Welder Outputs—Node 30
Note: The above information will be located in the SLC image table of the Scanner slot beginning with word #1. (i.e., If the scanner is
located in slot #2, word 0 will contain the status/control information, word #1 will contain bytes 0 & 1, word #2 will contain
bytes 2 & 3, etc.)
Host Input Image Table (Node 30)
Bit Global SCR#7 SCR#8 SCR#9 SCR#10 SCR#11 SCR#12
Byte 0
Byte 1
b
Byte 2
b
Byte 3
b
Byte 4
b
Byte 5
b
Byte 6
b
Byte 7
b
00 ID Bit #0 Reserved I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE I/O ACTIVE
01 ID Bit #1 Reserved WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS WELD IN
PROGRESS
02 ID Bit #2 Reserved NO FAULT NO FAULT NO FAULT NO FAULT NO FAULT NO FAULT
03 SIZE BIT #0 Reserved ALERT ALERT ALERT ALERT ALERT ALERT
04 SIZE BIT #1 Reserved END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE END OF
STEPPER/END
OF CAP LIFE
05 SIZE BIT #2 Reserved STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET STEPPER IS
RESET
06 SIZE BIT #3 Reserved WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE WELD
COMPLETE
07 SPARE Reserved READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD READY TO
WELD