OPERATION
17
−
The following shows the approximate disconnect times should you forget to
enter “
;H
” before hanging up:
Busy signal - 1 minute.
Ring back (no answer) - 3 minutes.
Both parties hanging up (call supervision provided by telephone
company) - 10 seconds.
No activity (silence for more than two minutes) - 2 minutes
Other - user programmed call length timer (5 minutes to infinity).
Call Back - Cellular Phones
Make sure your cell phone number is programmed as the call back number.
STEPS USER
DIALMATE
call DialMate from the cellular phone,
wait for one ring, and hang up
immediately
8
detects the ring, then dials
the call back number
Answer upon call back, wait for end of
message, if any, then enter the PIN
(e.g., “1234”). Do not press the
“SEND” button.
IJKL
wait for 2 beeps
Dial the destination number (up to 30
digits) followed by “
;
”. Do not press
the “SEND” button. (enter “*” before
the destination number to skip prefix)
QMM]
]]];
stores the dialed digits,
flash hooks, and dials the
prefix (if any) and the
number
wait for DialMate to connect the call,
then Proceed as in Call Back - Voice
DialMate flash hooks again
and connects the call
Call Back - Facsimile (Fax)
Set the fax machine’s reception mode to manual or set the fax machine to answer
after two or more rings before starting the call back operation.
STEPS USER
DIALMATE
Pick up the handset of the fax
machine and call DialMate. After
hearing one or two rings, hang up
immediately.
8
detects the ring, waits 8
seconds then dials the call
back number
Within 20 seconds, the fax
machine rings; answer immediately
after a single ring and wait for the
end of the recorded message, if
any.
plays back any recorded
message
