OPERATION
15
answer call, wait for end of
message, if any, then enter the
PIN (e.g., “1234”)
8
IJKL8
wait for two beeps
dial the destination number (up to
30 digits) followed by “
;
” (e.g.,
“14159556666#”)
(to skip prefix, enter “
P
” before
the destination number)
ILIMQ
MMNNN
N;
stores the dialed digits,
proceeds with 1
st
flash hook,
dials prefix (if any), then
dials the number
wait for DialMate to connect the
call
waits for 8 seconds or for 1
st
ring back, before doing a 2
nd
flash hook then dials any
pre-programmed suffix and
connects the call
engage in normal conversation
with called party
monitors the call for user
commands and disconnect
codes
to make another call, dial “
;^
”
;^8
disconnects the other party
wait for 2 beeps
8
dial next number (e.g., “955-
7777#”)
QMM]]
]];
same as above
dial “
;Q
” to enter REMOTE
PROGRAMMING
;Q8
wait for 1 beep
8
enter PIN (e.g., “1234”)
IJKL8
wait for 2 beeps
8
enter programming instructions A
through I, as applicable
8
dial “
;H
” to disconnect DialMate
before hanging up
;H8
disconnects and goes to idle
mode
Notes:
−
DialMate’s LED lights up every time DialMate goes “off hook”, or blinks
during a flash hook.
−
Enter your PIN during silent periods because voice playback and
background noise add distortion and may cause the device to disconnect
or not respond.
