ON-SITE PROGRAMMING
4
IV. ON-SITE PROGRAMMING
ON-SITE PROGRAMMING SETUP
Fig. 1 Connection diagram for on-site programming
⌦
LINE IN - Locate the telephone line that has “tone” and conference calling
capabilities and a telephone that is set to “tone”. Unplug the telephone
from the phone outlet modular wall jack or VOIP Analog Telephone Adapter
(ATA). Locate the supplied modular telephone cord and plug one end into
the wall jack or ATA. Plug the other end of the cord into “Line In”.
⌦
PHONE - Use the telephone cord attached to the telephone and plug the
free end of the telephone cord into DialMate’s jack labeled, “Phone”.
⌦
12VDC/9VAC - Plug the output of the supplied adapter into DialMate’s
power jack and then plug the adapter into a 120 VAC outlet that is not
connected to a wall switch.
PROGRAMMING INSTRUCTIONS
To enter programming mode, lift the handset of the telephone connected to
DialMate’s
“Phone” jack (you will hear no dial tone) and press the “
;
” key. After
hearing two beeps, follow the appropriate programming instructions below.
Initiate programming instructions within 3 seconds of the 2-beep prompt.
Otherwise DialMate will go out of program mode in which case, you will have to
wait at least 10 seconds and then press “
;
” again to get another 2-beep prompt.
Three beeps confirm successful programming and two beeps prompt for the next
instruction.