ON-SITE PROGRAMMING
6
−
To do an automatic call back for each caller, enter “
P\_IPIPIP
” as
the call back number. The device will call back the last caller that rang the
CM1003 once (for VOIP) or twice (for regular telephone lines) and then
hang up. This can only be done on lines that have the “Call Return”
feature. Note that the caller has to know the PIN to use the system.
Program C: Enable/Disable Call Forward/Transfer; Set Number of Rings
STEPS USER
DIALMATE
press “4”
L8
wait for the beep
8
to enable, press any key (e.g., “1”) 1 to 10 times
corresponding to the desired number of rings
before DialMate answers
IIII8
call forward/
transfer is
enabled
to disable, do not press any key
8
call forward/
transfer is
disabled
wait for the 2-beep confirmation/prompt for the next
instruction
8
DialMate will answer and forward/transfer incoming calls on the 4
th
ring, if enabled
For call forward/transfer function to operate properly, make sure that any
answering machine, fax or modem connected to the same line is set to answer
after a higher number of rings. When call forward/transfer is enabled, record an 8-
second voice message (see Program F) telling the caller to stay on the line as it
takes a few seconds to forward/transfer the call.
Note: When a single ring (desired number of rings before DialMate answers) is
chosen to trigger call forward/transfer, the normal call back mode is disabled.
However, call back can still be initiated by entering “
_
” during the remote
programming mode (see “Remote Programming”).
Program D: Setting the Call Forward/Transfer Number
STEPS USER
DIALMATE
press “8”
^8
wait for a beep
8
enter the call forward/transfer number
(e.g., “9 pause 14153550132”)
Q;BILIMK
MMHIKJ8
wait for the 2-beep confirmation/prompt for
the next instruction
8
DialMate will forward/transfer the call to ‘9, pause for 1.5 seconds, 14153550132’.
