Maintenance
Ceramic Guide Disks
Maintenance
30S97doc041910
5-6
5
After adjusting the drive side blade guide insert up, check the deflector. If necessary,
loosen the two deflector mounting screws and adjust the deflector so it does not touch the
blade.
Preventing sap buildup on the blade is critical when using the high-performance blade
guide system. If the wood you are sawing leaves sap buildup using plain water in the
blade lube system, use Wood-Mizer lube additive (4-Pak 60 oz. bottles part no. ADD-1).
FIG. 5-3
Tighten middle bolt to
raise ceramic disk
Loosen outer bolt nuts
and back bolts out slightly
Ceramic disk
(.008” - .010” from blade)
Loosen screws and
adjust deflector off of blade
if necessary (drive side only)
3H0837-1C
