Sawmill Setup
Tensioning The Blade
Sawmill Setup
30S97doc041910
3-9
3
3.4
Tensioning The Blade
See Figure 3-5.
Tension the blade by turning the hydraulic tensioning handle clockwise
until the tension gauge indicates the recommended tension.
See Table 3-1.
The recommended tension for different blades is shown below.
The tension gauge should be checked occasionally when adjusting the cant control or
while cutting. Ambient temperature changes will cause tension to change. Adjust the ten-
sion handle as necessary to maintain the recommended tension level.
CAUTION!
Changes in temperature could cause increased
pressure in the blade tensioner and loss of fluid from the
gauge. Release the blade tension when the mill is not in
use to avoid damage to the tensioner.
FIG. 3-5
Blade Type
Acceptable
Range
Ideal Tension
.035" x 7/8" x 1 1/4"
1800 - 2100 psi
2000 psi
.042" x 7/8" x 1 1/4"
2100 - 2400 psi
2300 psi
.045" x 7/8" x 1 1/2"
2100 - 2400 psi
2300 psi
TABLE 3-1
SM0243
Blade Tensioner
Gauge
Cant Control
Blade Tensioner
Handle
