Wood-mizer LT30, Safety, Setup, Operation & Maintenance Manual

Page: 107 / 191

5-36 30S97doc041910 Maintenance
MAINTENANCE LOG
(Check Engine And Option Manuals For Additional Maintenance Procedures)
Lubricate Blade Guide Rollers (If Applicable) See Section 5.2 Daily - Every 4 Hours
Check Blade Guide Block/Roller Wear See Section 5.2 Daily - Every Blade Change
DAILY MAINTENANCE PROCEDURES
Remove Excess Sawdust From Blade Wheel Hous-
ings And Sawdust Chute See Section 5.3 Daily - Every Blade Change
Inspect Fingers Inside Sawdust Chute See Section 5.3 Daily - Every Blade Change
Clean Sawdust From Battery Box Lid & Track Cover See Section 5.3 Daily - Every 8 Hours
Clean And Lubricate Track See Section 5.4 Daily - Every 8 Hours
Remove Sawdust From Upper Track Roller Housings See Section 5.4 Bi-Weekly - Every 25 Hours
Check Blade Guide Block Spacing (EZ-Glide Only) See Section 5.2 Bi-Weekly - Every 25 Hours
Clean And Lubricate Upper Track Wiper See Section 5.4 Bi-Weekly - Every 25 Hours
PROCEDURE
MANUAL
REFERENCE
TOTAL HOURS OF OPERATION
FILL IN THE DATE AND THE MACHINE HOURS AS YOU PERFORM EACH PROCEDURE.
A SHADED BOX INDICATES MAINTENANCE IS NOT NEEDED AT THIS TIME.
50 HRS 100 HRS 150 HRS 200 HRS 250 HRS 300 HRS 350 HRS 400 HRS 450 HRS 500 HRS
Clean & lube mast rails See Section 5.5
Lubricate drum switches See Section 5.6
Grease pivot points and bearings/Oil chains See Section 5.7
Lubricate blade tensioner handle and rods See Section 5.8
Rotate drive/idle blade wheel belts/Check for wear See Section 5.9
Check condition and adjustment of ceramic blade
guide disks (Ceramic Only) See Section 5.2
Check brake strap tension See Section 5.10
Check belt tensions See Section 5.11
See Section 5.14
See Section 5.15
Check blade throat screw See Section 5.2
Replace cylinder drive bearing fluid See Section 5.13
Check feed & up/down chain tensions See Section 5.14
See Section 5.15
Check up/down gear box fluid level See Section 5.14
Inspect power feed and up/down motor brushes See Section 5.14
See Section 5.15
Grease up/down shaft bearing See Section 5.14