Wood-mizer A/DH5, Safety, Setup, Operation & Maintenance Manual

Page: 5 / 134

Table of Contents Section-Page
Table of Contents SW-07doc1115173
2.9 DANGER! Hazardous voltage inside the electric box (even if disconnected with the main
disconnect switch) and at the motor can cause shock, burns, or death. Always disconnect
power supply before servicing!Hydraulic Control Operation ..............2-19
2.10 Loading, Turning, And Clamping Logs ...............................................2-22
2.11 Up/Down Operation .............................................................................2-24
2.12 Blade Guide Arm Operation.................................................................2-26
2.13 Power Feed Operation ..........................................................................2-26
2.14 Cutting The Log ...................................................................................2-28
2.15 Edging...................................................................................................2-29
2.16 Blade Height Scale ...............................................................................2-30
2.17 Water Lube Operation ..........................................................................2-32
2.18 Preparing The Sawmill For Towing .....................................................2-32
SECTION 3 MAINTENANCE 3-1
3.1 Wear Life................................................................................................3-1
3.2 Blade Guides ..........................................................................................3-1
3.3 Sawdust Removal ...................................................................................3-2
3.4 Carriage Track, Wiper & Scrapers .........................................................3-2
3.5 Vertical Mast Rails .................................................................................3-3
3.6 Miscellaneous .........................................................................................3-4
3.7 Blade Tensioner......................................................................................3-4
3.8 Blade Wheel Belts ..................................................................................3-5
3.9 Drive Belt Adjustment ...........................................................................3-5
3.10 Hydraulic System ...................................................................................3-8
3.11 Up/Down System....................................................................................3-9
3.12 Power Feed System ..............................................................................3-11
3.13 Safety Devices Inspection ....................................................................3-14
SECTION 4 TROUBLESHOOTING GUIDE 2-1
4.1 Sawing Problems ....................................................................................2-1
4.2 Electrical Problems.................................................................................2-3
4.3 Power Feed Problems .............................................................................2-4
4.4 Hydraulic Problems ................................................................................2-6
4.5 Engine/Motor and Drive Pulleys Alignment..........................................2-9
4.6 Hydraulic Pressure Test..........................................................................2-9
SECTION 5 SAWMILL ALIGNMENT 3-1
5.1 Pre-Alignment Procedures......................................................................3-1
5.2 Frame Setup............................................................................................3-2
5.3 Blade Installation And Alignment..........................................................3-2
5.4 Blade Wheel Alignment .........................................................................3-5
5.5 Adjusting The Lower Track Rollers.....................................................3-10
5.6 Adjusting Bed Rails To The Blade.......................................................3-12