SETUP & OPERATION
Preparing The Sawmill For Towing
SETUP & OPERATION
doc111517
2-33
2
1.
Move the cutting head to the front end of the sawmill. Raise the rear outriggers.
2.
Move the cutting head to the travel position over the rear bed rail.
3.
Put the distance block on the stop bolt.
See Figure 2-26.
4.
Position the hole in the cutting head over the travel rest pin.
5.
Lower the cutting head until it is seated firmly on the rest pin.
6.
Continue lowering the head 3/4” (19 mm) until it contacts the stop bolt located on the mast.
CAUTION!
It is important that the stop bolt is properly adjusted to
secure the carriage on the track rail. Failure to properly adjust the stop
bolt can cause cutting head damage, especially during mill
transportation.
7.
Hook the carriage safety chain attached to the main bed tube, behind the trailer to the bracket
located near the lower track roller.
8.
Manually lift the log loader and secure it with the safety chain.
FIG. 2-26
Distance Block
Stop Bolt
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
