SAWMILL ALIGNMENT
Horizontal Tilt Adjustment
5
5-27
doc111517
SAWMILL ALIGNMENT
5.15 Horizontal Tilt Adjustment
1.
Finally, both blade guides must be tilted horizontally. Adjust the blade guide arm halfway in.
See Figure 5-25.
2.
Place the Blade Guide Alignment Tool against the face of the outer blade guide roller.
3.
Center the tool on the roller and measure between the back edge of the blade and the ruler at the
end closest to the inner blade guide ("B").
4.
Measure between the back edge of the blade and the other end of the ruler ("A").
5.
The roller should be tilted slightly to the left (A = B - 6.0 mm [0.24"]).
6.
Use the side set screws to adjust the horizontal tilt of the roller.
7.
Repeat steps 3-7 for the inner blade guide roller.
NOTE:
Once the blade guides have been adjusted, any cutting variances are most likely caused by
the blade.
See the Blade Handbook, Form #600.
FIG. 5-25
50cm (19 11/16")
Turn side set screws
to adjust horizontal tilt
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
