SETUP & OPERATION
Blade Guide Arm Operation
2
2-26
doc111517
SETUP & OPERATION
2.12 Blade Guide Arm Operation
1.
Look down the length of the log to see its maximum width. The outer blade guide should be adjusted
to clear the widest section of the log by less than about 25 mm.
2.
Use the blade guide toggle switch on the control panel to adjust the outer blade guide as necessary.
Push the switch to the left to move the arm in. Push the switch to the right to move the arm out.
See Figure 2-21.
2.13 Power Feed Operation
See Figure 2-22.
The power feed system moves the carriage forward and backward by using two
switches on the control panel.
FIG. 2-21
20_120B
SW-08 Setworks
Real Size (mm)
Error calibration
Start autoprogram
AUTO
CAL.
SIZE
A,B,C
Position Size (mm)
NEXT CUT
A
B
C
Delete PROG.
Exit PROG.
PATTERN DOWN
Save PROG.
SAVE
PATTERN UP
BUMP UP
PROGRAM
Blade Guide
Arm In
Blade Guide
Arm Out
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
