SETUP & OPERATION
Middle Track Cover
2
2-14
doc111517
SETUP & OPERATION
Raise the two side supports to prevent the log from falling off the side of the mill when loaded.
See Figure 2-12.
2.4
Middle Track Cover
Before operating the sawmill do as follows:
1.
Clean the upper and lower rails to remove any sawdust and rust preventives.
2.
Unbolt and remove the middle track cover from its storage position.
3.
Soak the felt wiper with Dexron III transmission fluid, 10W30 motor oil or 3-in-1 turbine oil.
4.
Install the middle track cover so it fits against the rail and secure with two thumb screws.
FIG. 2-12
SM0130
Bed Rail
Stop Block
Pivot End Rail
Side Support
Side Support
Pivot End Rail
Bed Rail
Stop Block
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
