Troubleshooting Guide
Power Feed Problems
4
4-4
doc111517
Troubleshooting Guide
4.3
Power Feed Problems
PROBLEM
CAUSE
SOLUTION
Power Feed Is Jerky At Low
Speeds Or Does Not Move
Until Speed Is Above Halfway
Mark.
Drum switch is dirty.
Clean drum switch and lubricate with contact
grease supplied by Wood-Mizer.
Drum switch contacts are bad
Check that contacts are in good condition and
positively close circuit.
Speed switch is worn.
Replace the speed switch.
Speed switch is blocked.
Turn off the power for 20 seconds and turn it
back on.
Power Feed Is Jerky, But
Power Feed Motor Runs
Properly At All Speeds.
Problem is mechanical.
Refer to the Mechanical Test.
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
