SAWMILL ALIGNMENT
Saw Head Backlash Removal
SAWMILL ALIGNMENT
doc111517
5-18
5
5.9
Saw Head Backlash Removal
Check the saw head for backlash every 200 hours of operation. If necessary, remove the backlash.
See Figure 5-18.
To check if the backlash is present, grasp the outside part of the saw head and
move it as shown in the figure below. To remove the backlash, perform the following steps:
1.
Loosen the nuts on the adjustment bolts and the set screws shown in Figure 5-18, adjust the mast
guide rollers as shown in Figure 5-18.
FIG. 5-18
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
