MAINTENANCE
Miscellaneous
3
3-4
doc111517
MAINTENANCE
3.6
Miscellaneous
1.
Apply a thin film of a lithium grease to the blade guide arm to help prevent it from rusting.
2.
Lubricate the log turner (if equipped) with a lithium grease every fifty hours of operation. Lubricate
the turner pivot points (e.g. with WD-40).
3.
Grease the side supports with a lithium grease every 50 hours of operation.
4.
Oil all chains with an easily penetrating oil such as WD-40.
CAUTION!
Do not use chain lube. It causes sawdust buildup in chain
links.
5.
Check the mill alignment every setup. See Section 5, Alignment.
6.
Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any damaged
or unreadable decals immediately. Order decals from your Customer Service Representative.
3.7
Blade Tensioner
1.
Grease the tensioner handle screw with a lithium grease every fifty hours of operation, but at least
once a week.
50
50
50
50
50
Summary of Contents for A/DH5
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1115171...
Page 2: ......
Page 86: ...1 18 30doc111517...
