cyber
®
dynamic system
Operating manual
Revision: 01
Doc. no.: 5022-D056658
en-39
8 Maintenance and disposal
Opening the drive system voids the warranty.
Read the general safety instructions before beginning to work (see 2.13
”).
8.1 Maintenance work
8.1.1 Cleaning
Clean the drive system with a grease-dissolving, non-aggressive detergent.
8.1.2 Checking the holding brake
The drive system can be optionally equipped with a holding brake.
To ensure the permanent functioning of the holding brake, it has to be regularly applied and
checked.
-
It is recommended that the holding brake is released and applied at least twice daily
by deactivating the controller.
-
It is recommended that the holding torque M
4
of the brake is checked at least once
a day.
Details can be found in chapter 7.3
8.1.3 Visual inspection
Perform a
monthly
visual inspection:
Check the drive system and moving cables for damage.
Check whether the cable ends are completely labeled.
8.2 Repairs
The drive system may only be repaired by the manufacturer. Opening the drive system voids
the warranty and safety according to the specified standards is no longer ensured.
8.3 Information about the lubricant
It is not necessary to change the lubricant with this kind of drive system.
All motor bearings, gearboxes, and threaded spindles are permanently
lubricated at the factory.
8.4 Disposal
In accordance with WEEE 2002/96/EC directive, we take back old equipment for proper disposal
as long as the transport costs are paid by the sender.
