Configuration via Web Interface
2
017-
03
55
General Data
Burst Parameters
Caution!
System failure
If you click
Refresh
right after the device was switched on or reset, the system may stop
responding.
If the device was switched on or reset, wait about 1 minute until the boot process is complete
before you click
Refresh
.
Note!
If using the DTM and PACTware to configure the WirelessHART gateway, the following data is
available only during online parameterization.
Displayed
Information
Description
Long Tag
Displays the long tag of the device.
HART 5 devices and older devices do not support long tags. For those
devices, the WirelessHART adapter uses the content of the
Message
field
which will be displayed here instead.
I/O Card
Indicates the virtual I/O card number to which the device is mapped to. See
chapter 2.1.3
Channel
Indicates the channel of the virtual I/O card that the device is mapped to. See
chapter 2.1.3
The value 0 identifies a WirelessHART device or a WirelessHART adapter,
while the value 1 identifies a wired device connected to a WirelessHART
adapter.
Device Type
Displays the device type as registered at the HCF.
Status
The following communication statuses exist:
communication not possible
communication possible, device not identified
(flashing) communication possible, identification ongoing
device connected and identified
Dev. Status
Note that the device status displayed in the list may differ from the actual
device status because the HART status bits may be interpreted differently.
The following device statuses exist:
maintenance required
out of specification
check function
failure
Parameter
Description
+
To show/hide the list of burst messages for a device, click the + sign in the
+
column.
Burst
Command
Displays the HART command number and its description.
Num. Packets
Number of burst messages the device has sent.
Table 5.10 Burst Parameters
