Installation
2
017-
03
27
The WirelessHART gateway is now connected to the Ethernet network. The yellow
Ethernet communication status LED starts flashing when a correct HART or MODBUS
protocol message is received.
4. Tighten the cable glands with appropriate torque. See table "Installation torque for cable
glands and enclosure cover" on page 31
5. Seal empty cable glands with the provided plugs.
6. Tighten the enclosure cover with appropriate torque. See table "Installation torque for cable
glands and enclosure cover" on page 31
You do not need a RJ45 plug to connect the Ethernet cable to the WirelessHART gateway.
However, you need a RJ45 plug at the other end of the cable to connect the cable to an
Ethernet hub, switch, router, or PC.
Pinout of the RJ45 Plug
There are different standards for the RJ45 plug:
T568A
and
T568B
. The difference between
both standards is that some wires are connected to different pins of the plug.
Signal
Pins
Wire color of
T568A
plug
Wire color of
T568B
plug
TX+
1
White/green stripe
White/orange stripe
TX-
2
Green
Orange
RX+
3
White/orange stripe
White/green stripe
4
Blue
Blue
5
White/blue stripe
White/blue stripe
RX-
6
Orange
Green
7
White/brown stripe
White/brown stripe
8
Brown
Brown
87
65
43
21
