2
017-
03
44
Configuration via Web Interface
5.3.1
Serial Interface
The WirelessHART gateway can connect to the host system via an Ethernet interface or a
serial interface. This section describes the parameters for the serial interface.
Figure 5.7
Parameter > Wired Communication > Interfaces > Serial
Serial Interface Parameters
5.3.2
Ethernet Interface
The WirelessHART gateway can connect to the host system via an Ethernet interface or a
serial interface. This section describes the parameters for the Ethernet interface.
Figure 5.8
Parameter > Wired Communication > Interfaces > Ethernet
Parameter
Description
Default
Termination
Resistor
Selection
Select if you prefer to activate the termination resistor of the
WirelessHART gateway via the DIP switches inside the
enclosure (see chapter 2.3) or via software.
DIP switches
Termination
Resistor
Connect or disconnect the termination resistor of the
WirelessHART gateway. This drop-down list depends on the
value of
Termination Resistor Selection
. If the value of
Termination Resistor Selection
is "DIP switches", this
checkbox is read only.
Disconnected
Protocol
Selection
Select whether you want to use HART or MODBUS RTU for
serial communication.
HART
Table 5.4
Serial Interface Parameters
