Wilo DrainLift WS625, Installation And Operating Instructions Manual

Page: 14 / 86

English
10 Wilo AG 05/2005
• Only transport the product on the pallet and
only use approved handling equipment.
• Make sure the product is stable in transit.
• Prior to installation, store the product on the
pallet so that it remains dry and is protected
from the sun.
4 Use as intended
The Wilo DrainLift WS625 is used in combination
with a submersible pump as a pump station for
domestic sewage that is both free of faeces and
contains faeces in accordance with EN 12056-1. It
is used to drain drainage points in buildings and on
sites below the backflow level, where sewage
cannot drain into the public drains with a natural
gradient.
WARNING! Health hazard!
Because of the materials used, this product is
not suitable for supplying drinking water! Con-
taminated sewage is a health hazard. Do not use
the pump station inside buildings.
CAUTION! Risk of damage!
The introduction of inadmissible substances
into the drains can cause damage to the product.
Never introduce solids, fibrous substances, tar,
sand, cement, ash, coarse paper, debris, rubbish,
animal waste, grease, oil or swimming pool
water into the drains!
Use of the product as intended also means follow-
ing these instructions.
Use over and beyond the use described is not use
as intended.
5 Product information
5.1 Type code
5.3 Dimensions
The main dimensions are shown in mm on the
dimension drawing (Fig. 1) - for further informa-
tion, see data sheet/catalogue
5.4 Scope of supply
• Wilo DrainLift WS625>, consisting of the
components (Fig. 2):
1
plastic shaft
2 internal pipework
2a pressure outlet
2b gate valve
2c pipe screw connection
3
inflow connection with seal
4 connection for ventilation/cable duct with
seal
5 chain hooks
• Installation and operating instructions
NOTE:
If it is to be used as a pump station, accessories are
needed that have to be ordered separately (see
Accessories).
Example: WS 625 E / 1500
WS Series: W ilo shaft pump station S ynthetic
625 Pump shaft diameter [mm]
E E = Individual pump
1500 Shaft height [mm]
5.2 Technical data Note:
max. admissible pressure in the 6 bar in combination with pump MTS 40
pressure pipe: 4 bar in combination with pumps TMW32, TC40
Pressure pipe connection DN40 PE pipe, connection via clamp bolting
Inflow connection DN 100
Ventilation connection / cable bushing DN 100
max. admissible ambient temperature: 20°C ground, below depth of 0.5 m
max. admissible groundwater level: 800 mm above bottom of shaft, permanent
to top of shaft max. 1 week
Storage volume see data sheet/catalogue
Suitable pump types see data sheet/catalogue
Suitable Wilo shaft cover see catalogue/see Accessories Note application according to EN 124!
Type H [mm] A [mm]
WS 625 E / 1200 1260 -
WS 625 E / 1500 1560 900
WS 625 E / 1800 1860 1200
WS 625 E / 2100 2160 1800