Wildlife Acoustics sm3bat, User Manual

Page: 53 / 86

SM3BAT User Guide Developing Custom Programs
page
47
BIOACOUSTIC MONITORING SYSTEMS
AT SSET±hh:mm:ss
Causes the program to wait until sunset, plus or minus the specified time.
REPEAT
Indicates the beginning of a loop. Must be ended by an UNT command.
UNTDATE DDMMMYY
Ends a loop when the specified termination date is reached. Any RECORD
commands in progress in this loop are forced to stop recording.
UNTTIME hh:mm:ss
Ends a loop when the specified termination time is reached. Any RECORD
commands in progress in this loop are forced to stop recording.
UNTSRIS±hh:mm:ss
Ends a loop at sunrise, plus or minus the specified time. Any RECORD
commands in progress in this loop are forced to stop recording.
NOTE : Some commands listed in this section refer to sunrise or sunset in a general
sense and depend on them in program calculations. The recorder recognizes different
methods for calculating precise sunrise and sunset times. To specify a method and
view the next available sunrise and sunset times, select Sunrise/Sunset Type in the
Settings menu.
UNTSSET±hh:mm:ss
Ends a loop at sunset, plus or minus the specified time. Any RECORD
commands in progress in this loop are forced to stop recording.
UNTCOUNT {<count>, INF}
Ends a loop after <count> iterations. INF specifies an infinite count.
FEATURE <feature number> {OFF,ON}
This is for advanced use only and is not a required command by the
program checker. The first parameter is a number from 1 to 16 and the
second parameter is OFF or ON. By default, all features are OFF.
■
FEATURE #01: If ON, disables the LED blinking during recording. Insert
into the top of a program "01 FEATURE 01 ON" to disable the LEDs.
■
FEATURE #02: If ON, enables 32-bit recording mode. 32-bit mode is
only enacted with very specific program settings and is intended for use
only with SM3M Marine recorders.
This command may be used to add additional features in the future.