10
WIKA operating instructions pneumatic high pressure controller, model CPC7000
0019104001D 10/2018EN
EN
2. Short overview
2.2 Turning On
You can confirm that your CPC7000 is operational right now. Apply power to the power connector on the rear of the instrument
with the included power cord, remove any plastic plugs from the rear panel pressure ports, and press the power switch to ON. The
system will go through an initialization process, which takes about 30 seconds, and then a display will appear similar to the screen
shown below
Earth Ground! Any power adaptors or surge protection devices that negate the protective earth ground
should not be used. The power cord must be accessible and contain a protective earth ground. Do not
position the equipment so that it is difficult to remove the power cord.
Ventilation! Do not block airflow to ventilating fans located on rear of instrument.
To see information about the configuration of your new CPC7000, touch the Next Page Button [
] then the Information
Application (App) icon [
] on the menu and a window will appear listing the Mensor contact information, model number and the
transducers that are installed. Press the Previous Page Button [
] then the Home App [
] to return to the main screen.
Figure 2.2 Information application
Power Switch ON/
OFF
