Stopping the WhisperGen
TM
Operation
18
Stopping the WhisperGen
Manual Stopping
The default setting of the
Heat Manage
option is
OFF
. Unless it is turned
ON
, the WhisperGen
TM
automatically stops once the battery bank is fully
charged - you do not need to manually stop the unit.
Should you wish to manually stop the WhisperGen
TM
, refer to the following:
1. Hold
down
STOP
on the control on the control panel until a beep is
heard. The
STOPPING
indicator lights up and "Running down" is
displayed on the control panel. As an anti-tamper feature, short
presses of the
STOP
key are ignored.
R
In the stopping mode, as indicated by a lit
STOPPING
indicator, the
WhisperGen
TM
goes through a shutdown sequence lasting two to five
minutes during which the engine is cooled down.
When the WhisperGen
TM
has fully stopped, the
STANDBY
indicator lights
up and the control panel displays "WhisperGen". The WhisperGen
TM
must
be in the standby mode before it can be started again.
If a remote switch has been installed to control the WhisperGen
TM
, you can
also stop the WhisperGen
TM
with the remote switch, refer to section entitled
Remote Controlling for more details.
If you stop the WhisperGen
TM
manually or from a remote switch when it is
auto-charging the battery bank, the WhisperGen
TM
will immediately start
again if the battery bank charge level is still below the set level.
To prevent the WhisperGen
TM
from restarting, turn the
Auto-charge
option
OFF
, refer to section entitled Managing the Battery Bank - Auto charging.
TM
Summary of Contents for PPS16-12MD
Page 1: ...user s manual Part Number WP 5012 001 01 ...
Page 2: ......
Page 4: ......
Page 8: ......