2-6
Run water for a few seconds through hoses into a laundry tub,
drainpipe or bucket to prevent clogs. Water should run until
clear.
10.
Connect inlet hoses to washer
11.
Check for leaks
9.
Clear water lines
Attach hot water hose to hot water inlet valve marked with a red
ring. Screw coupling by hand until it is snug. Use pliers to tighten
couplings an additional two-thirds turn. Repeat with cold water
inlet valve.
IMPORTANT: To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates for
future reference.
■
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
CONNECT INLET
HOSES
Washer must be connected to water faucets with new inlet
inlet valves. If you are only connecting to a cold water
faucet, you must use a Y-adapter (not provided).
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT:
Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
HELPFUL TIP:
Make note of which hose is connected to hot
water to help in attaching hoses to washer correctly. In most
attached correctly.
Connect inlet hoses to water
faucets
8.
hose form from the end of the drain hose. You may need
additional parts with separate directions. See “Tools and Parts”.
7.
Remove drain hose form
INSTALLATION REQUIREMENTS (continued)
Summary of Contents for Cabrio WTW5700XW
Page 58: ...4 22 NOTES ...
Page 84: ......
