Whirlpool Cabrio WTW5700XW, Technical Education

Page: 62 / 84

5-4
FOR SERVICE TECHNICIANS ONLY
AUTOMATIC TEST MODE
To access Automatic Test Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LED’s or display correspond as follows:

“Spin” LED On, “ 02
” Displayed on 7-segment
02
Sensing Soak Wash Rinse Spin Done
Press the
START button to begin the automatic
test. See page 8 for order of automatic test.

Upon entering the automatic test mode, the
washer will perform an automatic test with
water cycles to check major washer functions.

Pressing the
START button will manually
advance to the next step.
NOTE: Lid must be closed with lid lock enabled
to perform test.
MANUAL TEST MODE
To access Manual Test Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LED’s or display correspond as follows:

“Spin & Done” LED On, “ 03
” Displayed on
7-segment
03
Sensing Soak Wash Rinse Spin Done
Press the START button to enter Manual Test
Mode. See page 9 for manual test mode.

Upon entering the manual test mode,
the washer will have all outputs OFF.

The cycle selector knob is used to select
the output to be tested.

When the selected output is activated, the
corresponding status LED’s fl ash ON & OFF.

The START button will activate/deactivate
the selected output.
IMPORTANT:
As a safety feature, the lid
must be closed with lid lock enabled to
activate either Agitate or Spin Test.
NOTE:
Multiple outputs may be activated
simultaneously.
NOTE: Outputs left on will time-out after
5 minutes.
CALIBRATION MODE
IMPORTANT:
Calibration must be performed
when any of the following components
have been replaced: Main Control, Basket,
Drive Assembly, Motor, and Capacitor. Not
performing calibration will result in poor
wash performance.
To access Calibration Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LED’s or display correspond as follows:

“Rinse” LED On, “
04
” Displayed on 7-segment
04
Sensing Soak Wash Rinse Spin Done
Press the START button to begin washer calibration.

Lid must be down to perform test.

Basket must be empty to perform test
(no water or clothes).

Calibration cycle runs for approximately
2-3 minutes. Cycle completes when door
unlocks and washer enters standby mode.

Do NOT interrupt calibration, disturb washer,
remove power, or press POWER button;
otherwise, calibration must be repeated.
SALES DEMO MODE
NOTE:
For retail use only. To access Sales Demo
Mode, perform steps 1 and 2 of Activating the
Service Diagnostic Modes. Turn the cycle selector
knob until the status LED’s or display correspond
as follows:

“Rinse & Done” LED On, “ 05 ” Displayed on
7-segment
05
Sensing Soak Wash Rinse Spin Done
Press the START button to begin the Sales Demo.

To exit Sales Demo Mode, the washer
must be powered down. It may be
necessary to unplug the washer or
disconnect power to disable the
Sales Demo.