Whirlpool Cabrio WTW5700XW, Technical Education

Page: 15 / 84

2-5
Remove tape from washer lid, open lid and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Keep tray in case you need to move washer later.
Remove packing tray from drum
3.
Firmly grasp power cord plug and pull to free from rear panel.
Gently place power cord over console to allow free access
to back of washer.
4.
Free power cord
CONNECT DRAIN HOSE
If clamp is not already in place on elbow end of drain hose,
slide it over end as shown. Squeeze clamp with pliers and
slide black elbow end of drain hose onto black drain port
and secure with clamp.
Attach drain hose to drain port
5.
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT: 4.5" (113 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay on
bottom of laundry tub. Drain hose form must be used.
6.
Place drain hose in standpipe
4.5"
(113 mm)
For a laundry tub or standpipe drain, go to step 6.
shown in Step 7. You may need additional parts with separate
directions. See “Tools and Parts”.
Drain
hose form
INSTALLATION REQUIREMENTS (continued)