4
Function Catalogue
Save multiple
sets of set parameters and switch freely when needed
Name a group of model parameters
Select helicopter,airplane or multicopter
Copy one group of model parameters to another group of model parameters
Reset a group of model parameters to initial value
Set low battery alarm point
On/Off sound
Adjust backlight brightness, light time
Set trainer or simulator function
Input letter or number,as a user name
Modify the screen back colour
Calibrate the neutral point of ailerons, elevations, accelerators, directional
channel rocker and the position of the upper, lower, left and right endpoints
Select suitable operation stick mode
Select English or Chinese interface language
Reset all parameters of transmitter
Display the unit setting
Calibrate the panel screen
Transmitter system information
24
24
25
26
26
27
27
27
28
29
29
29
30
30
30
30
31
31
System Setting
Model Select
Model Name
Model Type
Model Copy
Model Reset
Low Voltage
Sound
Backlight
Trainer/Simulator
User Name
Back Color
Calibration
Stick Mode
Language
Factory Reset
Telemetry Unit
Screen Cal
Information
32
33
33
34
35
36
36
36
Linkage Setting
Link Step
Telemetry
Servo Frequency
Range Check
Fail Safe
W.BUS Servo
PPM/W.BUS
Rx Port Setting
Transmitter and receiver link
Display the set sensor data
The servo working frequency
Reduce the power to remote control range check
When the receiver lost the signal, it automatically loads the preset scheme
for the body action safety protection
Set servo
Switch the output mode of receiver
Set the output channel of receiver port
37
37
37
38
39
40
40
40
40
41
41
General Menu
Monitor
Servo Reverse
Sub-Trim
Timer
Dual Rate
End Point
Trim Step
Aux Channel
Channel Delay
Program Mix1-3
Curve Mix1-2
Monitoring and displaying the output status of each channel
Set each channel reverse to match the neutral point of each model channel
Adjust the netrual point of each channel
Set flying alarm time to help remind battery or fuel capacity
Adjust the channel output value to adapt the dual rate of each model channel
Channel end point and limit position
Set the trimming step value of each channel
Customize the switch of 5-10 channel
Set the delay value
Mixing the output of 2 random channels
Mixing the 2 ramdon channels of curve controlled
