15
Stick Adjustment
Left and right stick mode replacement method
It is not recommended to replace the left and right sticks by yourself, otherwise the transmitter may be
damaged. (Your free warranty would be lost if you replaced your left and right sticks )
Required tools: 3 mm cross screwdriver, 1.5 mm hex driver
First open the transmitter housing and then follow the instructions shown below:
1
Loosen the bearing housing screws (the screws do not need to be fully retracted), then remove
the spring, bracket 7 and bracket 5 and tighten the screws
; then remove the removed spring, bracket 7
and bracket 5 in another assembly corresponding position (remove the bearing housing screw before
assembly),The tightness of the stick can be changed by adjusting the height of screw 3.
2
Remove the screw of the throttle reed, the throttle reed and the throttle sleeve, and install them
in the corresponding position of the other assembly. According to your own habits, select the type
of throttle sliding (toothed and smooth) and adjust the screw (screw 1 or The height of the screw 2)
makes the damping of the throttle conform to your own habits.
Screw
１
Screw
２
Screw 3
Throttle sleeve
Throttle reed
After the throttle structure is modified, turn on the machine, enter [system setting] → [stick mode], select
the corresponding operation mode, and then adjust the stick after replacing the left and right modes!
If you need components such as bracket 5 (such as the parts needed for assembling double circuit
structure!), you can e-mail to WFLY overseas seller to order the spare parts at sales@wflysz.com
Bracket 5
Bracket
7
Spring
①
Throttle sleeve
Basic Operation
