User Guide
4. Part Replacement
4.14 Chassis Replacement
Figure 383:
Safety Latch Release
e.
As the chassis is slid into the rack, position one installer at the rear of the rack to ensure
that the pegs on the sides of the cover will slide correctly into the rear cover alignment
brackets on both sides of the rack. If the chassis does not install smoothly or snags, check
that the rear cover alignment brackets are not interfering with the chassis sidewalls, and
try again.
Step 50 :
Secure the chassis top cover to the rack using the captive M5 thumb-screws as shown in the
following image. Use a T15 Torx screwdriver, and tighten the screws to 3.38-3.61 Nm / 30-32 in-
lbf.
Figure 384:
Cover Retention Screws
Step 51 :
Now that the chassis is installed, test the installation by sliding the enclosure in and out of the
rack a minimum of three times. If the enclosure binds, catches, or displays any incorrect motion
or behavior repeat the installation.
298
